Cre3dController @Cre3dController

Custom Repairable Ergonomic 3D Printed Controllers cre3dcontroller.com Joined December 2020

Tweets

55
Followers

96
Following

40
Likes

70

Cre3dController @Cre3dController

4 years ago

One of the things I've been working on is a pc app for customizing and uploading button layouts and response curves. You can store several layouts and curves on the controller and swap between them on-the-fly. App doesn't need to run while in-game, config stored on the 🎮

1 2 6 0 0

Download Image

Cre3dController @Cre3dController

5 years ago

Cant praise this enough. Been thinking someone should do this but personally dont have the knowledge/experience with low latency wireless systems. If they open source the schematics too I will definitelty look into integrating their wirelss solution in my controllers.

G-wolves @g_wolves

5 years ago

47 62 556 0 12

Download Image

0 2 8 0 0

Cre3dController @Cre3dController

5 years ago

Rumor has it that ReWASD is allowed in Fortnite now. If true, that's good for the future of controller getting more customizable binds and something equivalent to scroll wheel reset.

2 0 10 0 1

Cracky901 @Cracky9011

5 years ago

Perfect timing @Cre3dController for the new season! She'll be used when I get home later tonight! Thanks for all the extras, I do have some questions on how to put stuff on though 😂

2 2 5 0 0

Download Image

Cre3dController @Cre3dController

5 years ago

Shipping first thing tomorrow! More news on the next batch in a few weeks.

2 2 6 0 0

Download Image

Cre3dController @Cre3dController

5 years ago

Print is 91% finished. This one is gonna be close 😂

1 0 6 0 0

Download Image

Cre3dController @Cre3dController

5 years ago

If you're interested in other 3d printed controller projects you can check this guy out. Definitely a compelling option if you don't mind playing claw and still replacing their controller frequently. Next version replace adhesives with a clip and reinforce the connector/cable?

Controlla Scrolla @CScrolla

5 years ago

13 7 61 0 2

Download Image

0 0 5 0 0

Cre3dController @Cre3dController

5 years ago

Production mode

2 1 9 0 0

Download Image

Cre3dController @Cre3dController

5 years ago

Power is back on at home finally so I can start printing again. Hope everyone who still doesn't have power is staying warm.

1 0 6 0 0

Cre3dController @Cre3dController

5 years ago

Made a snap in faceplate for covering the switches more and also made a slide-in plate that reduces key travel ~1.25mm. Bit tricky to install/remove because you have to slide it in without removing the keycaps but way better than O-rings which barely reduce travel.